After a renovation the garage door is often the last piece that still looks like the old house. We help you choose a style, colour and window layout that fits the new face of the home, measure the opening and install it cleanly.
From the shop
Before work starts you will know exactly what we intend to do and what it involves. If we find something else while the door is apart, we stop and show you, and you decide whether to add it. Nobody should learn about extra work from the invoice, and nobody should be talked into a part they did not need.
— Riverview Door & Opener Co.
Hours
Garage door services
Garage doors rarely fail all at once. They give hints first, and this list is arranged around those hints. Match the one you have noticed and you will see what the visit involves and which parts are usually behind it.
Repairs
From a wobble in the panels to a draft under the door, the repair and maintenance services deal with the wear a door collects through years of daily use and hard winters.
Springs
Spring size is chosen by measurement, not by guess: wire thickness, inside diameter, length and the door's weight all matter. The services in this group start with those measurements so the new spring matches the door rather than the old part.
Openers
Whether the opener was installed last year or twenty years ago, the services here keep it working: repairs where they make sense, replacement where they do not, and programming of every device that talks to it.
New Doors
An older home with an original wood door often has an opening that is out of square. Fitting a new door into it well takes care with the jambs and the tracks, and that care is what makes the door seal and run straight.
Insulated Steel Garage Door Installation
Wind-Rated Garage Door Replacement
Carriage-House Garage Door Installation
Full-View Glass Garage Door Installation
New-Construction Garage Door Installation
Commercial Sectional Door Repair
Commercial Rolling Door Repair
High-Lift Garage Door ConversionMississauga
Garage Door Opener Replacement
During the ice storm the power was off for two days. You came home in the dark, found the door dead, and had to climb out of the car to pull the red cord in the cold. A door that keeps working through an outage is now on the list.
Garage Door Opener ReplacementUsuallyEmergency release and manual lift.
WhyThe red cord disconnects the door from the opener so it can be raised by hand if it is balanced.
UsuallyTrolley re-engagement.
WhyThe trolley needs to be lined up with the carriage; a stuck or damaged release lever can be repaired.
UsuallyEmergency release repair.
WhyA new cord and handle, and a check that the release lever moves freely.
UsuallyTorsion Spring Replacement
WhyThe finished result is a door that behaves the way a good garage door should: it lifts by hand with light effort, stays where you leave it at mid-height, closes softly and lets the opener run with little strain.
UsuallyExtension Spring Replacement
WhyChoosing the right spring is a matter of weight, not colour.
UsuallyGarage Door Balance Adjustment
WhyWhat you get back is a door that lifts with light, even effort and a written note of how it was set.
Open 24/7
The finished result is a door that behaves the way a good garage door should: it lifts by hand with light effort, stays where you leave it at mid-height, closes softly and lets the opener run with little strain. Reaching that point involves measuring the door, choosing a matched spring, winding it…
1 of 3
Call or write with what you noticed. We will tell you what it likely means and what the visit will involve, so there are no surprises.
2 of 3
The technician walks through the door's operation with you, then goes over each component, pointing out wear as they find it.
3 of 3
The agreed work is completed, the garage is left tidy, and the door is tested in both directions with you watching.
Peel, Ontario
2021 census · what it means at the door
38%Homes of every age
About 38% of homes in Mississauga were built in 1980 or earlier, according to the 2021 Census.
A mixed-age neighbourhood is where retrofits are most common: safety cables added to extension springs, a torsion conversion on an older door, insulated panels replacing a hollow door, or a quieter belt opener under a newly finished room above the garage. Each is a routine job for us.
37%
Single-detached houses make up about 37% of homes in Mississauga (2021 Census).
In condominium communities the outward appearance of a garage door is often set by the corporation's rules, down to colour and panel style. We check what the board expects before ordering a replacement door, so the new one is approved and matches the row without a second conversation.
Low-headroom garages use a different arrangement: the spring assembly may be mounted at the rear of the horizontal tracks, or special low-headroom drums and track bring the door up with less clearance. Replacement follows the same principles, but the drums, cable routing and turn count differ. The technician identifies the system on arrival and brings hardware that suits it, so the door balances correctly in the space available.
The kindest thing for the door is to leave it where it is and use another entrance. An opener is designed to move a door the springs have already made light; asking it to lift a full-weight door strains the trolley and gear drive and can crease the top section. Keeping the door still and clear of people until the spring is replaced protects the rest of the system from extra repairs.
The shaft is free during a spring change, which makes it the natural time to renew the centre bearing and end bearings if they grind or wobble. Lift cables that show fraying or rust at the bottom brackets are replaced so the new spring pulls on sound steel, and cracked or worn drums are swapped. On older doors, a corroded centre bracket or loose lag bolts may also be addressed. Each item is shown and explained before it is added.
Not necessarily, and that is fine. The paint colour on the winding cone or coil is a code that identifies wire size and wind direction, and different suppliers use their own schemes, so a matched replacement can carry a different colour than the spring it replaces. What matters is that the wire size, diameter, length and wind direction suit the door's weight and height, which is confirmed by the balance test.
Yes. The sensors are wired to the head unit, and the app or hub simply talks to that unit, so nothing about the connection changes. What you will notice is the fault code clearing: apps that reported the sensors as obstructed or not aligned show the door as ready to close again. If an app or hub still holds an old code after the work, refreshing it or cycling the door from the app once clears it.
On-site assessment preferred
Request a diagnosis visit. Describe what you noticed.
Open 24/7 · same fees any hour
On-site assessment preferred · (289) 374-3208 · open 24/7
